VETRON 5000 Programming Manual page 13

Hide thumbs Also See for 5000:

Basicily

The adjustments for e.g. stitch length, thread tension, foot pressure

and other settings are made with equipment like knobs, switches

and dials on conventional sewing machines. This settings are not

accurate repeatable after changing them.

With the VETRON these settings are made by step motors, they

can exactly reproduce the desired setting. All settings like stitch

length, thread tension and foot pressure for example are adjusted

with parameters on the controler.

Single- and Chainprogams

A complete setting of the machine is called a program and can

be stored under a name or a number. A change of progam can be

done with a push of a button and all adjustments are carried out.

Multiple settings of di erent machines can be united in one machine.

It is also possible to concatenate several programs. They will run

automatically one after another. This is called a chain program.

A progam can be used as a single program, or be linked in a chain

program. Changes in a program will be active in a chain program.

For this reason it is advisable to store the parts of a chain progam

separately e.g. with a number higher than 50 upwards.

PROGRAMMING MANUAL

Messurement of the material thickness

The machine is ﬁtted with a electronic device

can register the thickness of the material. This device

enables the machine to react independently to di erent

requirements within one seam, depending on the con-

ﬁguration. The thread tension, foot pressure and stitch

length will be adjusted with increasing material thickness.

Notice when switching on machine

The system will calibrate itself every time you switch the

machine on. Also after pushing the safety switch (X-Key)

calibration will take place. Calibration must take place

without material under the sewing foot. The needle plate

surface is 0 mm material thickness.

PROGRAMMING MANUAL VETRON 5000 13

09. GENERAL

that