VETRON 5000 Programming Manual page 24

PROGRAMMING MANUAL
12. PROGRAM PARAMETER
-9-14
5
NR. PARAMETER
» ALLOCATION OF HOTKEYS
085
086 Handwheel function (
087 Knee switch function
24 PROGRAMMING MANUAL VETRON 5000
DESCRIPTION
TENSSW
TENSTG
NEEDLE
TARGET
) Same functions as parameter 085, when the electronic handwheel is pushed
1
You have the same function as parameter 085.
Additional can be activated as follows:
NEEDLE
TARGET
SL SW
SL TGL
= Thread tension switch from A1 to A2 for this program. (By pressing
and holding the key you will switch to the 2
hold the key. You will go back to the 1
the button) (also for two-needle machines B1and B2).
= Thread tension switch from A1 to A2 for this program. (By press-
ing the key you will switch to the 2
it will switch back to the 1
machines B1to B2).
= By pressing the key the machine will switch to the 2
position (needle up). By pressing it again it will switch back to
the 1 st position (needle down).
= By pressing the key the machine will go to the target stitch position.
Needle point just above the material.
(Target stitch position parameter 078).
= You can switch o the signal for the needle centering
on two-needle machines.
= You can switch between stitch in stitch backtack and normal
backtack within a seam.
= When knee switch is activated the machine will switch over
to the 2 stitch length. As long as you hold the knee switch
nd
2 stitch lenght is applied.
nd
= When the knee switch is touched the 1
to the 2 stitch length. By touching the knee switch again it
nd
will go back to the 1 stitch length.
st
1
4
2
3
tension as long as you
nd
tension setting by releasing
st
nd tension. By pressing it again
tension setting. (also for two-needle
st
needle
nd
st time it will switch
.
1