Error Code - Siruba ASP-PTA100 Original Instructions Manual

錯誤代碼
代碼
Code
通訊異常
E01
Network error
缺料顯示
E02
Show lack of material
運料氣缸未確實處於
準備點 / 原點位置
E11 Cylinder for material transmission
does not stay in standby/original
position well
前伸氣缸未確實縮回
E12
Forward cylinder does not retract well
塑形氣缸未確實下降
E14
Forming cylinder does not lower well
夾料臂未確實到待命令位置
E16 Clamp does not arrive standby point
well
擋邊氣缸未確實退回
E18 Guide block cylinder does not return
well
若於運料時，運料失敗，導致成型區
感應器未判讀有料，夾爪不會執行前
伸動作
- If transmitting material is not well,
sensor on forming part does not detect
material. Clamp will not forward and
catch material
P11
說明
Description

ERROR CODE

備註
Memo
見 4. 故障排除 章節
Ref. by paragraph 4.Trouble shooting
待載料平台下降，進行補料後，按下重置鍵
Lower material platform, fill material and press
reset button
1 號氣缸 / 準備點微動開關 / 原點磁簧開關異常
No. 1 cylinder/standby point micro switch or
original point reed switch error
2 號氣缸 / 磁簧開關異常
No. 2 cylinder/reed switch error
4 號氣缸 / 磁簧開關異常
No. 4 cylinder/reed switch error
6 號氣缸 / 磁簧開關異常
No. 6 cylinder/reed switch error
8 號氣缸 / 磁簧開關異常
No. 8 cylinder/reed switch error
按下 重置鍵 再次進行運料動作
Press reset and feed material again