Siruba ASP-PTA100 Original Instructions Manual page 20

2. 成型角度不足
夾具有對應摺痕５ｍｍ或６ｍｍ寬的夾槽，
當成型角度不足時， 會發生進料失敗的情形，
此時需更換正確的夾槽才能順利成形。
P15
2.Incorrect forming angle
Clamp need to match ５ｍｍ or ６ｍｍ width
clamp slot. When the forming angle is not
enough, feeding process will be error. In such
situation, we need to replace correct clamp
slot to form it correct.
夾角過大
Too large angle
進料失敗
Failure to
feed material