Siruba ASP-PTA100 Original Instructions Manual page 27

（３）單縫模式（補縫模式）
開啟電源後，在單動模式下按下人機介面數
字鍵８即進入單縫模式，此時自動送料機構
停止動作。主要用於人工摺紙卡再進行車縫
或補縫用。
（４）單捲線模式
此模式下可單獨捲線
注意！！啟動此模式前請將車針拆下避免撞
斷車針
依照下列順序進行。
A. 將 " 電源開關① " 切至ＯＦＦ。
B. 將 " 電源開關① " 切至Ｏ N。
D. 按下 " 準備鍵② " 變成Ｏ N。
E. 按下 " 準備鍵② " 變成ＯＦＦ。
G. 按下 " 運轉鍵③ "，使其燈號在 " 捲線圖案
" 上亮起。
H. 按下 " 準備鍵② " 變成Ｏ N。
I. 按下 " 起動鍵④ " 即可運轉。
J. 捲完線，按下 " 起動鍵④ " 即可停止。
②
捲線圖案 Winding symbol
（３）Only sewing mode (re-sew mode)
After turning on the power, press number "8"
on the panel in step mode to enter only sewing
mode. Then, automatic feeder stop working.
This mode is mainly designed for users to fold
label by hand and then to sew or to re-sew it.
（４）Only winding mode
We could only wind in this mode.
Notice ！！ Please remove sewing needle to
prevent crushing the needle before activating
this mode.
Follow below sequences:
A. Turn OFF "Power switch ① ".
B. Turn ON "Power switch ① ".
D. Press "Ready ② " to become ON.
E. Press "Ready ② " to become OFF.
G. Press "Operarion ③ " to turn on "Winding
symbol" light.
H. Press "Ready ② " to become ON.
I. Press "Activation switch ④ " to run.
J. After winding, press "Activation switch ④ " to
stop.
④
③
Introduction
①
P22