Advertisement
Parameters
Parameter Function
P07
Up position adjustment
P08
Down position adjustment
Needle goes up
automatically as power
P09
turned on
Machine protection
P10
switch selection
P11
Speed curve adjustment
P15
Stitch Correction Mode
P21
Motor rotate direction
P22
Auto running speed
P23
Auto running time
P24
Auto running stop time
P25
Item A test
P26
Item B test
P36
Type
Note: the initial value of parameters is for reference only, and the actual value of parameters is subject to the real object.
4 Error Code List
Error Code
E01
Over-voltage
E02
Low-voltage
E03
CPU communication error
Speed control unit connection is
E05
abnormal
E07
Motor locked-rotor error
Range
0-24
0-24
0-1
0-2
1-100
0-3
0-1
200-6000
1-250
1-250
0-1
Problem
Default
0
12
0: No Function
1: Power turned on, needle goes up position
1
automatically
0：Disable
1：Testing zero signal
0
2：Testing positive signal
The lager the value, the faster to increase
32
speed
0: Half stitch
1: One stitch
3
2: Continuous correct half stitch
3: Continuous correct stitch and quickly stop
machine
1
0: clockwise 1: counter-clockwise
3500
Auto running speed setting
20
20
0
Continue running with constant speed
0
Carry out the set loop running
1
Status / Measurement
Turn off the system power supply, and detect whether the
supply voltage is correct. (Or exceed the rated voltage.)
If correct, please replace the control box and inform the factory
Turn off the system power supply, and detect whether the
supply voltage is correct.
specified in use.)
If correct, please replace the control box and inform the factory
Turn off the machine, please check if the operation panel in
bad connection or is too loose. To get it right and turn on. If
there are still errors, please replace the control box and call
for customer service.
Turn off the system power supply, please check the speed
control unit connector if loose or fall off, Will resume normal
after the restart system
If you still cannot work normally, please replace the speed
control unit and notify the manufacturer.
Turn the machine handwheel, check if it is stuck. If it is stuck,
you have to rule out the mechanical failure.
If turn normal, check if the encoder and motor in bad
connection or is too loose. If yes, please correct.
If connection well, check if the power supply voltage is
abnormal or sewing speed is too high. If yes, please adjust.
- 3 -
Description
(Or exceed the rated voltage
Advertisement
