Label Installation And Alignment - Siruba ASP-PTA100 Original Instructions Manual

紙卡安裝與對位
1. 紙卡尺寸變更時
依紙卡摺痕中心至左及右邊的長度來調整
滑塊對應的刻度，寬度亦是如此。
2. 紙卡摺痕偏移調整
若紙卡摺痕偏離夾具位置時，需微量調整紙
卡安裝位置以符合夾持位置。
摺痕
Crease
紙卡
Label
夾具
Clamp

LABEL INSTALLATION AND ALIGNMENT

1.When label dimension changes
According to label crease center, adjust
length between left border and right border
and then adjust width by the same way.
紙卡摺痕中心
Label crease center
2.Adjust the deviation of label crease
If label crease deviates from the clamp
position, fine tune the installation position of
label to fit clamp position.
Introduction
P6