Siruba ASP-PTA100 Original Instructions Manual page 21

夾槽選用錯誤時將產生成形角度不足的問題
摺痕 6mm 寬的紙卡
6 width Label
mm
crease
6mm 寬的夾槽
6 width clamp slot
mm
夾槽更換方式
鬆開螺絲將夾棒拆下後，可拆除夾槽
內鎖固螺絲再進行更換夾槽作業
After loosing screws and remove
clamp rod, we could remove locking
screws in clamp slot and then start
to change clamp slot
夾棒
Clamp rod
夾槽
Clamp slot
Introduction
If choosing wrong clamp slot, it will result in
the problem of not enough forming angle.
摺痕 5mm 寬的紙卡
5
5
mm
Exchange of clamp slot
width Label
mm
crease
5mm 寬的夾槽
width clamp slot
P16