1. 紙卡疊料
吸盤吸附紙卡兩張以上時,將造成夾具無法
開夾而異常,此時可以調整吹氣嘴的角度與
吹氣量大小來進行疊料排除。(註:紙卡若
因印刷油墨沾黏則需人工排除)
氣嘴調整方式
Air nozzle adjustment
1. Labels overlap
When suction cup catches more than 2 labels,
clamp will not open and error. In this situation,
we can adjust the angle of air nozzle and the
strength of air blow to remove material stack
(note: users will need to remove by hand if
labels stick together by ink or else)
需使用 3mm 六角板手伸入氣孔調整吹氣角度
Need to use 3 m m hex wrench to enter air
inlet to adjust the angle of blowing air
Introduction
氣嘴
Air nozzle
旋轉螺桿可調整吹氣量大小
Able to adjust blowing strength
by rotatory screw rod
P14