Trouble Shooting - Siruba ASP-PTA100 Original Instructions Manual

異常排除
現象
Description
摺痕未對夾具中心
Crease is not in the clamp
middle
縫線未在紙卡正中心
Sewing line is not on the label
middle.
預定位置
實際位置
Assigned
Actual location
location
縫線未在指定位置
Sewing line is not on assigned
location
預定位置
Assigned
location
實際位置
Actual location
夾槽無法開啟
Unable to open clamp
slotlocation

TROUBLE SHOOTING

原因
Reason
1. 紙卡安裝位置偏移。
2. 夾具機構位置錯誤。
1.Label position
deviates
2.Clamp position error
1. 紙卡安裝位置偏移
1.Label position
deviates
1. 擋邊氣缸位置錯誤
1.Wrong position of
guide block cylinder
1. 疊料造成
1.Materials overlap.
Introduction
對策
Solution
1. 微調料槽長度滑塊位
置。
2. 調整氣缸束環位置。
1.Fine tune length
sliding block position
of material platform
2.Adjust the position of
cylinder limiting ring
微調料槽寬度滑塊位
置及限位塊。
Fine tune position of
width sliding block
and limiting block
微調擋邊氣缸固定座的
鎖固位置。
Fine tune fixed position
of guide block cylinder
seat
吸盤分料時，調整吹嘴
角度與風量使疊料分
離。
When suction cup
catches material,
adjust the angle of air
nozzle and the strength
of air to separate
material stack.
參考頁數
Ref. page
P .00~P .00
P .00
P .00~P .00
P .00
P .00
P12