New Module Software Assistant - Emerson Rosemount 370XA System Reference Manual

System Reference Manual
7P00370-H01
4.4.7

New Module Software Assistant

When you install a new analytical module on the 370XA and turn on
the power, the GC will recognize that a new module has been
installed and will start the New Module software assistant, which will
heat up the oven, run carrier gas through the analytical paths, and
cycle the analytical valves to rapidly purge the system.
NOTICE
The New Module software assistant can also be initiated from the LOI or MON2020
by selecting Module Validation on the Tools menu.
NOTICE
Changing the CPU board will also start the New Module software assistant because
of the mismatch between the CPU board and the analytical module. In this case,
you should stop the assistant by pressing
4 - 42
370XA Gas Chromatograph
.
APRIL 2014