Web Management Interface - D-Link DSA-3600 Quick Install Manual

Hide thumbs Also See for DSA-3600:

Table of Contents

1.5 Web Management Interface

The DSA-3600 provides a web management interface for configuration. After completing the hardware

installation, the administrator can configure the DSA-3600 via web browsers with JavaScript enabled, such

as Internet Explorer version 6.0 or above.

First, set a PC as DHCP in the network TCP/IP setting to get an IP address from DHCP server automatically.

Next, connect the PC to the DSA-3600 via any LAN port. An IP address will be assigned to the PC

automatically via DSA-3600 built-in DHCP server. Launch a web browser to access the web management

interface of DSA-3600 by entering "https://192.168.1.1" in the URL. (Note: https is used for secured

connection.)

Once the DSA-3600 has been connected, the Administrator Login Page will appear. Enter "admin" for both

the default username and password in the Username and Password fields, and then select the Enter button

to log in.

Note: When the DSA-3600 is new or has just been reset back to the factory default settings (with firmware

version 3.00.00 or later), the Setup Wizard (see next page) will automatically show up after reboot. You can

choose to follow the Wizard instructions or ignore this step.

After successfully logging into the DSA-3600 at the first time, the Setup Wizard will appear automatically.

After the second time logging in, the System Overview page of the web management interface will appear.

To logout, simply click the Logout icon on the upper right corner of the interface to return to the

Administrator Login Page.

DSA-3600 Quick Install Guide

Table of Contents