Layer 3 Dynamic Aggregation Configuration Example - H3C SR8800 Configuration Manual

[DeviceA] link-aggregation load-sharing mode source-ip destination-ip
Configure Device B:
2.
Configure Device B using the same instructions that you used to configure Device A.
Verify the configurations:
3.
# Display summary information about all aggregation groups on Device A.
[DeviceA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
RAGG1
The output shows that link aggregation group 1 is a load-sharing-capable Layer 3 static
aggregation group that contains three Selected ports.
# Display the global link-aggregation load sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load sharing criteria are the source and
destination IP addresses of packets.

Layer 3 dynamic aggregation configuration example

Network requirements
As shown in
• Configure a Layer 3 dynamic aggregation group on Device A and Device B respectively and
configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination IP addresses.
Figure 29 Network diagram
Configuration procedure
Configure Device A:
1.
# Create Layer 3 aggregate interface Route-Aggregation 1, configure the link aggregation mode
as dynamic, and configure an IP address and subnet mask for the aggregate interface.
AGG Partner ID
Mode
S none
Figure 29:
source-ip address
89
Select Unselect Share
Ports Ports Type
3 0 Shar