H3C SR8800 Configuration Manual page 156

Verify the configuration:
3.
# Display the global LLDP status and port LLDP status on Router A.
[RouterA] display lldp status
Global status of LLDP : Enable
The current number of LLDP neighbors : 2
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,4 minutes,40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [GigabitEthernet4/1/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 2 [GigabitEthernet4/1/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
The output shows that: GigabitEthernet 4/1/1 of Router A connects a MED device, and
GigabitEthernet 4/1/2 of Router A connects a non-MED device. Both ports operate in Rx mode,
in other words, they only receive LLDP frames.
# Tear down the link between Router A and Router B and then display the global LLDP status and
port LLDP status on Router A.
[RouterA] display lldp status
Global status of LLDP : Enable
The current number of LLDP neighbors : 1
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: 0
: Enable
: Rx_Only
: No
: 0s
: 1
: 0
: 0
: 0
: 3
: 30s
146