Table of Contents
Advertisement
Configuring a Layer 2 static aggregation group
To configure a Layer 2 static aggregation group:
Step
1.
Enter system view.
2.
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
3.
Exit to system view.
4.
Assign an Ethernet interface
to the aggregation group.
5.
Assign the port an
aggregation priority.
Configuring a Layer 3 static aggregation group
To configure a Layer 3 static aggregation group:
Step
1.
Enter system view.
2.
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
3.
Exit to system view.
4.
Assign an Ethernet interface
to the aggregation group.
Command
system-view
interface bridge-aggregation
interface-number
quit
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
Command
system-view
interface route-aggregation
interface-number
quit
•
Enter Layer 3 Ethernet interface
view:
interface interface-type
interface-number
•
Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
76
Remarks
N/A
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
N/A
Repeat this step to assign more
Layer 2 Ethernet interfaces to the
aggregation group.
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the static aggregation group.
Remarks
N/A
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
N/A
Repeat this step to assign more
Layer 3 Ethernet interfaces to the
aggregation group.
Advertisement
Table of Contents
