Table of Contents
Advertisement
Step
7.
Assign the port an
aggregation priority.
8.
Set the LACP timeout interval
on the port to the short timeout
interval (1 second).
Configuring a Layer 3 dynamic aggregation group
To configure a Layer 3 dynamic aggregation group:
Step
1.
Enter system view.
2.
Set the system LACP priority.
3.
Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
4.
Configure the aggregation
group to work in dynamic
aggregation mode.
5.
Exit to system view.
6.
Assign an Ethernet interface
to the aggregation group.
Command
link-aggregation port-priority
port-priority
lacp period short
Command
system-view
lacp system-priority system-priority
interface route-aggregation
interface-number
link-aggregation mode dynamic
quit
•
Enter Layer 3 Ethernet interface
view:
interface interface-type
interface-number
•
Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
78
Remarks
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the dynamic aggregation group.
Optional.
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Remarks
N/A
Optional.
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in the dynamic
aggregation group.
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
By default, an aggregation group
works in static aggregation mode.
N/A
Repeat this step to assign more
Layer 3 Ethernet interfaces to the
aggregation group.
Advertisement
Table of Contents
