H3C SR8800 Configuration Manual page 100

10g core routers layer 2 - lan switching
Hide thumbs Also See for SR8800:
Table of Contents

Advertisement

<DeviceA> system-view
[DeviceA] interface route-aggregation 1
[DeviceA-Route-Aggregation1] link-aggregation mode dynamic
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces GigabitEthernet 4/1/1 through GigabitEthernet 4/1/3 to
aggregation group 1.
[DeviceA] interface gigabitethernet 4/1/1
[DeviceA-GigabitEthernet4/1/1] port link-aggregation group 1
[DeviceA-GigabitEthernet4/1/1] quit
[DeviceA] interface gigabitethernet 4/1/2
[DeviceA-GigabitEthernet4/1/2] port link-aggregation group 1
[DeviceA-GigabitEthernet4/1/2] quit
[DeviceA] interface gigabitethernet 4/1/3
[DeviceA-GigabitEthernet4/1/3] port link-aggregation group 1
[DeviceA-GigabitEthernet4/1/3] quit
# Configure Device A to use the source and destination IP addresses of packets as the global
link-aggregation load sharing criteria.
[DeviceA] link-aggregation load-sharing mode source-ip destination-ip
Configure Device B:
2.
Configure Device B using the same instructions that you used to as you configure Device A.
Verify the configurations
3.
# Display summary information about all aggregation groups on Device A.
[DeviceA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
AGG
Interface
Mode
-------------------------------------------------------------------------------
RAGG1
D
The output shows that link aggregation group 1 is a load-shared Layer 3 dynamic aggregation
group and it contains three Selected ports.
# Display the global link-aggregation load sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load sharing criteria are the source and
destination IP addresses of packets.
Partner ID
0x8000, 000f-e2ff-0002
source-ip address
90
Select Unselect
Share
Ports
Ports
Type
3
0
Shar

Advertisement

Table of Contents
loading

Table of Contents