Display Of Battery Charge Level Without Additional Devices; Display Of The Current Charge Level Using The Cockpit App; Preparation For Use; Alignment - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Preparation for use

6.3.1 Display of battery charge level without additional devices

Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see Page 31).

6.3.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:
7 Preparation for use

7.1 Alignment

The following alignment guidelines contain descriptions for connecting the knee joint to a prosthetic socket. In
principle, the alignment of the prosthesis is independent of the type of connection for the knee joint. In case of a
connection to an osseointegrated, percutaneous implant system, a socket is not used during bench alignment in
the alignment apparatus. In this case, the central proximal point on the prosthetic socket corresponds to the
trochanter of the thigh bone (see illustration in the section "Bench alignment in the alignment apparatus" see
Page 21).
Ensure that possible flexion or adduction of the transfemoral residual limb can be compensated to a permissible
extent by an adapter approved by the implant manufacturer in the course of static alignment optimisation. Safe
functioning of the knee joint is only guaranteed with biomechanically correct alignment.

7.1.1 Shortening the Tube Adapter

CAUTION
Incorrect processing of tube
Falling due to damage to the tube.
► Do not clamp the tube into a vice.
► For shortening the tube, use only a tube cutter.
1) Determine the required length of the tube adapter using the configuration assistant in the adjustment software.
2) Shorten the tube adapter to the determined value with the 719R3 tube cutter.
20
1) Rotate the prosthesis 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beeps.
Vibration signal
3x long
5x long
1. 38% – Charge level of battery for currently connected component
Battery charge level
more than 80%
65% to 80%
50% to 65%
35% to 50%
20% to 35%
less than 20%
C-Leg 3C98-3/3C88-3