Mitsubishi Electric A960GOT User Manual page 71

6 HANDLING
6 - 24
The following hardware versions have been improved so that less space is
necessary for inserting/removing a memory card.
You can now open a cover of the memory card interface section to insert/remove it.
Item
A975GOT
A970GOT
A960GOT
(1) Mounting
OFF ON
(2) Dismounting
OFF ON
• You cannot open the cover of the memory card interface section when a
communication module is mounted on the GOT.
Type
A975GOT-TBA (-B)
A975GOT-TBD (-B)
A970GOT-TBA (-B)
A970GOT-TBD (-B)
A970GOT-SBA
A970GOT-SBD
A970GOT-LBA
A970GOT-LBD
A960GOT-EBA
A960GOT-EBD
1) Set the memory card access switch of the GOT
to "OFF" and make sure that the memory card
LED goes off.
When the PC card LED goes off, the memory
card can be loaded/unloaded while power is on.
2) Open the memory card interface cover.
3) Insert the PC card into the memory card
interface with the PC card facing up.
(Place a PC card on the memory card interface
section of the GOT, and slide it in place.)
1) Set the memory card access switch of the GOT
to "OFF" and make sure that the memory card
LED goes off.
When the PC card LED goes off, the memory
card can be loaded/unloaded while power is on.
2) Open the memory card interface cover.
3) Remove the PC card after fully pushing the
memory card ejection button of the GOT to eject
the PC card.
The PC card may pop out when it is being
removed, depending on the type of the PC card
used. Be sure to support the card with your
hand when removing it.
MELSEC-GOT
Hardware Version
Version L (jun., 2001) or later
Version H (jun., 2001) or later
6 - 24