Mitsubishi Electric A960GOT User Manual page 61

6 HANDLING
Grounding to the panel with the cable
clamps
Cable clamps
6 - 14
g) CRT cable (CRT cable enclosed with CRT)
• Wind cable shield material around the cable, and pull out the
grounding braided wire of the cable shield material with the length
shown below.
• The cable must be 1.5m or shorter.
GOT side
Ferrite Core (ZCAT3035-1330)
Within 100
(3.94)
(3) Grounding the cable
Ground the cable grounding sections and grounding wire to the control panel
where the GOT and base unit are grounded.
Cable shield material
Grounding braidedwire (50mm(1.97inch))
• Bus connection cable (For A8GT-C100/ C200/300EXSS,
A8GT-C100/200/300BS) ground the shield braided wire
and grounding wire to the panel with a cable clamp
(AD75CK).
• Ground the shield braided wire of the RS-232C cable, CC-
Link dedicated cable and Twisted pair shielded cable to
the panel with the cable clamps.
• Ground the other bus cable, RS-422 cable and printer
cable grounding braided wires to the panel with a screw.
MELSEC-GOT
CRT side
Unit : mm (inch)
6 - 14