Mitsubishi Electric A960GOT User Manual page 6

[Startup/Maintenance Precautions]
• Do not disassemble or modify the module.
Doing so can cause a failure, malfunction, injury or fire.
• Do not touch the conductive and electronic parts of the module directly.
Doing so can cause a module malfunction or failure.
• The cables connected to the module must be run in ducts or clamped.
Not doing so can cause the module or cable to be damaged due to the dangling, motion or
accidental pulling of the cables or can cause a malfunction due to a cable connection fault.
• When unplugging the cable connected to the module, do not hold and pull the cable portion.
Doing so can cause the module or cable to be damaged or can cause a malfunction due to a
cable connection fault.
[Backlight Changing Precautions]
• Before changing the backlight, always switch off the GOT power externally in all phases (when
the GOT is connected to the bus, the PLC CPU power must also be switched off externally in all
phases) and remove the GOT main unit from the enclosure.
Not switching the power off in all phases may cause an electric shock.
Not removing the unit from the enclosure can cause injury due to a drop.
• When replacing the backlight, use the gloves.
Otherwise, it may cause you to be injured.
If you should directly touch the plated area of the main unit case with hand, be sure to wipe off
the fingerprint and so on, and install the main unit case.
Otherwise, it may cause a trouble or malfunction.
• Start changing the backlight more than 5 minutes after switching the GOT power off.
Not doing so can cause a burn due to the heat of the backlight.
[Disposal Precautions]
• When disposing of the product, handle it as industrial waste.
A - 5
CAUTION
!
DANGER
!
CAUTION
!
CAUTION
!
A - 5