7
Position of the Pick-Up Guide Plate Cam (multifeeder assembly)
Adjust the engagement of the 26T gear 1 and 26T gear 2 so that the paper guide
plate and the paper guide plate cam are as shown in Figure 2-43 when the solenoid plate
is in contact with the claw of the control ring.
8
Routing the Timing Belt (multifeeder assembly)
Butt the rack plate of the multifeeder against section A (open state).
Move the slide volume in the direction of B, and attach the timing belt to the pulley.
26T gear 1
Paper guide plate
Paper guide plate
cam
Figure 2-43
Timing belt
Pulley
Rack plate
Slide volume
Figure 2-44
CHAPTER 2 STANDARDS AND ADJUSTMENTS
Control ring
Claw
Solenoid plate
26T gear 2
Section A
Pulley
B
2-31