Stack Delivery Mode - Canon Finisher-T1 Service Manual

3) Turn on the host machine.
- When this mode item is enabled, the
machine changes its operation it executes
after the start of stack edging, thus
ensuring that the paper will be stacked
properly.
- When this mode item has been enabled,
changes in conditions (e.g., the use of
paper with little curl or delivery of paper
with downward curl) can prevent the
machine from stacking the paper properly.
It is important, therefore, to be sure of the
type of paper used by the user before
enabling this mode item.
4.3.1.5 Stack Delivery
Mode
a. Outline
Depending on the selected paper handling
mode*, condition
environment, the trailing edge of paper can
rain against the stacking wall and prevent
the machine from stacking it correctly
(also causing it to prematurely detect an
over-stack condition; see the following
figure).
*For instance, in stack delivery mode other
than when the stack consists of 6 or fewer
sheets of small-size paper.
0009-2567
of paper, and
F-4-9
If this is the case,
1) Turn over the stack of paper inside the
source (e.g., cassette). If doing so has made
upward curling worse than before, turn
back over the stack. If the upward curling
still causes the machine to fail to stack the
paper correctly, try enabling stack delivery
mode:
b. Enabling Stack Delivery Mode
1) Turn off the host machine.
2) Set the bits of SW104 on the finisher
controller PCB as follows:
ON
1 2 3 4 5 6 7 8
F-4-10
3) Turn on the host machine.
- When this mode item is enabled, the
machine changes its operation it executes
after stack edging to make sure that the
Chapter 4
4-7