Buffer Roller - Canon Finisher-T1 Service Manual

F-3-29
3) Lift tray 2 [1] to remove it.
[1]
F-3-30
When installing the tray, be careful not
to twist the tray cable. To prevent the
gear phase from shifting due to the front
and rear rails, the tray must be attached
horizontally. Lower the tray [1] to the
position shown in the figure and
[2]
[1]
compare the heights of the shutter guide
top edges [2] with those of the tray
projections [3] at the front and rear to
check that the
horizontally. If their heights are not the
same, remove the tray and then attach it
again.
[2]
[1]
F-3-31

3.3.4 Buffer Roller

3.3.4.1 Removing the
Front Door
Refer to Procedure 3.1.5
3.3.4.2 Removing the
Escape Tray Cover
Refer to Procedure 3.1.6
Chapter 3
tray is attached
[3]
0009-4513
0009-4428
3-15