E584;Shutter Malfunction - Canon Finisher-T1 Service Manual

NO : Replace the sensor.
Tray 2 shift area sensor PCB
2) Check the tray 2 shift area sensors 1 to 3. Do the sensors operate normally?
NO : Replace the tray 2 shift area sensor PCB
Wiring
3) Is the wiring between the finisher controller PCB and tray 2 shift motor nor-mal?
NO : Repair the wiring.
Tray up/down mechanism
4) Is there any abnormality in the tray up/down mechanism?
YES : Repair the tray up/down mechanism.
Tray 2 shift motor (M108)/Finisher controller PCB
5) Does it improve when the tray 2 shift motor is replaced?
YES : End
NO : Replace the finisher controller PCB.

4.4.1.11 E584;Shutter malfunction

Shutter home position sensor (PI113)
1) Check the shutter home position sensor. Does the sensor operate normally?
NO : Replace the sensor.
Wiring
2) Is the wiring between the finisher controller PCB and stack ejection motor, and between
the finisher controller PCB and shutter clutch normal?
NO : Repair the wiring.
Shutter mechanism
3) Is there any abnormality in the shutter mechanism?
YES : Repair the shutter mechanism.
Stack ejection motor (M102)/Shutter clutch (CL101)/Stack ejection lower roller clutch
(CL102)/Finisher controller PCB
4) Does it improve when the stack ejection motor, the shutter clutch and the stack ejection
lower cluch are replaced?
YES : End
NO : Replace the finisher controller PCB.
Chapter 4
0009-2598
4-15