E584; Temporary Functional Limit - Canon Finisher-T1 Service Manual

Chapter 5

5.3.11 E584

Code Detail

E584

8001
0002

5.3.12 Temporary Functional Limit

1. Overview
The machine has a feature to temporarily enter the limited operation mode to perform only
paper delivery, when an error is encountered. The machine can continue to operate in this
limited mode until the error is removed.
In the limited operation mode, stapling, alignment, and punching (only applicable when
equipped with optional puncher unit) are not performed, while the inlet sensor (PI103),
escape tray path sensor (PI118), and feed path sensor (PI104) remain enabled to detect any
jam.
2. Operation
1) When the host machine has started up, use service mode or user mode as follows:
1-a) Service Mode
Set '1' for the following: SORTER>OPTION>MD-SPRTN.
1-b) User Mode
Press [limit function mode]; when a Confirmation screen has appeared, press [yes].
3) Turn off and then on the main power switch of the host machine.
3. Communication with the Host Machine
5-10
T-5-14
Error Description
Stack ejection
motor (M102)/
Shutter open/
close clutch
(CL101)/Shutter
home position
sensor (PI113)/
Stack ejection
lower roller
clutch (CL102)
Detection timing
The stapler does not leave the shutter home
position when the stack ejection motor has been
driven for 3 seconds.
The stapler does not return to the shutter home
position when the stack ejection motor has been
driven for 3 seconds.
0009-2692
0009-2693