Chapter 3
[1]
[3]
F-3-16
2) Remove the stack delivery roller front
side E ring [1], gear [2], parallel pin [3], E
ring [4], washer [5], and bearing [6].
The parallel pin [3] drops when the
gear [2] is removed. Be careful not to
loose it.
3-10
[2]
[2] [3]
[1]
F-3-17
3) Remove all finisher controller PCB
connectors[1] and remove the harness
from two clamp [2].
4) Remove four screws [3] and remove the
finisher controller PCB [4].
[1]
[3]
F-3-18
5) Release the claw [1] of the stack
delivery roller rear side clutch [2] and
[4]
[5]
[6]
[2]
[4]
[2]
[3]