Canon Finisher-T1 Service Manual page 77

3.3.7.3 Removing the
Escape Tray Cover
Refer to Procedure 3.1.6
3.3.7.4 Removing the
Front Inside Upper
Cover
Refer to Procedure 3.1.4
3.3.7.5
Removing the
Escape Unit
1) Disconnect four connectors [1] and
remove the harness from two clamps [2]
and harness guide.
F-3-35
2) Remove three screws [1] at the back of
the escape unit.
0009-4482
0009-4526
0009-4527
[2]
[2]
[1]
3) Remove the three screws [1] at the front
of the escape unit.
[1]
[1]
4) Lift the escape unit slightly and remove
it.
Chapter 3
[1]
[1]
[1]
F-3-36
F-3-37
3-19