Paper Delivery Path - Canon Finisher-T1 Service Manual

Chapter 2

2.2.3 Paper Delivery Path

0009-2512
<Overview>
There are three ejection paths to tray 1 and 2 depending on the ejection processing. There
is only one paper ejection path to the escape tray.
<Straight Ejection (Destination: Tray 1/ Tray 2)>
When the equipment is set to non-sort, all copies are ejected through the following path.
Stack ejection roller
Tray
Paper
1st delivery roller
Buffer roller
Feed roller
Stack ejection roller
Inlet roller
F-2-7
<Processing Tray Path (Destination: Tray 1/ Tray 2)>
This is the copy ejection path when the equipment is set to sort for paper size other than A4,
B5, or LTR or when set to staple sort. Copies are delivered to the processing tray for
aligning and stapling. Then they are ejected using the rear end assist.
2-7