Canon Finisher-T1 Service Manual page 116

No. Description
[3] Model LED
[4] Power LED
[5] RS-232C cable (straight
full wiring; 9 pins)
[6] Cable A (9 pins) Length:
approx. 70cm
[7] Cable B (9 pins)Length:
approx. 50cm
[8] RS-232C connector
3. Necessary Tool
The following item needs to be prepared for download.
Computer (PC)
Prerequisite: The download tool (Ver. 3.11E or higher) must be downloaded to the PC.
4. Download Procedures
a. Registering ROM data
1) Store ROM data to be downloaded in the 'C:\ServTool\NewROM' folder.
2) Start up the Service Support Tool.
C:\ProgramFiles\Service Support Tool\bpchost.exe
3) Select [Register System Software].
Function
To be lit when the Finisher is connected.
To be lit when power is supplied from the Finisher to the
downloader PCB
A cable to connect the downloader PCB and a PC.Be sure to
connect the cable in a way that its ferrite core comes to the PC
side.
A cable to connect the downloader PCB and other products
A cable to connect the downloader PCB and the Finisher
A connector to connect an RS-232C cable to the downloader
PCB
Chapter 4
4-31