Tray 2 - Canon Finisher-T1 Service Manual

[3]
[3]
F-3-24
4) Lift tray 1 [1] to remove it.
[1]
F-3-25
When installing the tray, be careful not
to twist the tray cable. To prevent the
gear phase from shifting due to the front
and rear rails, the tray must be attached
horizontally. Lower the tray [1] to the
position shown in the figure and
compare the heights of the shutter guide
top edges [2] with those of the tray
projections [3] at the front and rear to
[1]
check
horizontally. If their heights are not the
same, remove the tray and then attach it
again.
[2]
[1]
[2]

3.3.3 Tray 2

3.3.3.1
Refer to Procedure 3.1.5
3.3.3.2
Refer to Procedure 3.1.1
that the
[2]
[1]
F-3-26
Removing the
Front Door
Removing the
Rear Upper Cover
Chapter 3
tray is attached
[3]
0009-4508
0009-4511
3-13