Canon Finisher-T1 Service Manual page 95

Chapter 4
stapled paper manually to verify the
staple position because it is not ejected.
7) Press SW103 on the finisher controller
PCB once.
8) If the staple position is correct, insert a
sheet of paper between the aligning plates
and push it against the stopper, push the
far end edge of the paper to the rear
aligning plate, and press SW103 once
(stapling action/store adjustment value)
and proceed to step 11).
9) To adjust the staple position, press
SW101 or SW102 on the finisher
controller PCB and adjust the staple
position.
When SW101 is pressed, staple position
moves 0.49 mm forward.
When SW102 is pressed, staple position
moves 0.49 mm backward.
10) Repeat steps 5) and 6) and check that
the staple position is adjusted correctly.
11) Turn off all bits of SW104 on the
finisher controller PCB.
12) Turn off the power of the host machine
and install the rear cover of the finisher
unit.
4-10