Escape Unit - Canon Finisher-T1 Service Manual

Chapter 3
3.3.6.5 Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.2
3.3.6.6
Removing the
Tray 1
Refer to Procedure 3.3.2
3.3.6.7
Removing the
Tray 2
Refer to Procedure 3.3.3
3.3.6.8 Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.3
3.3.6.9
Removing the
Stapler
Refer to Procedure 3.1.3
3.3.6.10 Removing the
Processing Tray
Refer to Procedure 3.2.1
3.3.6.11 Removing the
Swing Unit
Refer to Procedure 3.2.2
3-18
Upper
0009-3688
0009-3689
0009-3690
Lower
0009-4521
0009-3692
0009-3693
0009-3695
3.3.6.12 Removing the
Return Roller Unit
1) Remove the return roller unit front side
connector [1] and remove the harness from
two clamps [2].
2) Remove the spring [3] and three screws
[4] and pull out the return roller unit [5]
from the front side.
F-3-34

3.3.7 Escape Unit

3.3.7.1
Removing the
Front Door
Refer to Procedure 3.1.5
3.3.7.2
Removing the
Rear Upper Cover
Refer to Procedure 3.1.1
0009-3679
0009-4522
0009-4524