Canon Finisher-T1 Service Manual page 46

Chapter 2
<Last Sheet>
When alignment of the last sheet completes, the finisher controller PCB moves the aligning
plate to alignment position with the aligning motor (M103/M104) (with the paper held with
the aligning plate). Then the finisher controller PCB staples at the specified staple position.
After stapling, the finisher controller PCB starts the swing motor (M106) and lowers the
swing guide. Then the stack is ejected by the stack delivery roller, return roller, and rear
endassist guide.
Stack ejection roller
Swing guide
Return roller
Rear end assist guide
Stapler
F-2-31
2-28