...................................................................................................................................................................................................................................

Overview

The procedures described below must be performed in case of a software download

failure occurred with the fast download application or if the fast download application

cannot be used.

For installing the NE software manually 2 procedures must be performed:

• NE software download into an NE

• Switch the Software Stores of the NE.

These procedures can also be performed separately.

Before you begin

Before starting the NE software download make sure:

• The required controller software is available on the management system or on

floppy disk.

• There is sufficient time to complete the procedure. The procedure lasts about one

hour.

• not to download software into the backup store while the active store is not

committed. As long as the active store is not committed the NE may perform an

automatic switch.

• not to forget to commit the software after performing a switch. If this is not done

the NE will switch back to the previous active software after 2 hours.

Related information

Parameters used in this procedure can be found in section

installation" (p.

NE software download

Proceed as follows to perform the NE software download:

...................................................................................................................................................................................................

Select

Result:

the software currently stored in the active and backup store of the NE.

...................................................................................................................................................................................................

Click

Result:

...................................................................................................................................................................................................

Click

B-4

B-7).

Provisioning → Equipment → NE Software Configuration

The NE Software Configuration window appears with information about

Edit.

The Edit NE Software Configuration window appears.

Download.

Alcatel-Lucent - Proprietary

See notice on first page

"Parameters for NE software

365-312-802R7.2