Optical Sfp Module - Alcatel-Lucent 1643 AMS Installation Manual

System cabling
Optical interfaces (AMS unit/X5IP card)
...................................................................................................................................................................................................................................
Overview
Two
aggregate
one-gigabit interface is available on the X5IP option card.
Optical connectors
The optical interfaces can be equipped with various SFPs (Small Form-Factor
Pluggable Optics). All SFPs are equipped with LC connectors. The next figure shows
the variable SFP module system.
Figure 4-51 Optical SFP module
NOTES:
•
Please note that Alcatel-Lucent warranty is contingent upon the use of
Alcatel-Lucent specified SFPs for 1643 AMS. Use of other SFPs is not
approved by Alcatel-Lucent and is fully at the customer's own risk. Any
warranty obligation of Alcatel-Lucent is extinguished when non-Alcatel-Lucent
specified SFPs are used.
• It is not mandatory to have an LBO (Lightguide Build-Out) between the SFP and
the connected optical cable. However, in the case of measurements with optical
loops and/or connecting power meters an LBO (15 dB) can be required. An LBO
can also be necessary to ensure the correct input power (see chapter 8, section
"Connecting the fiber cables" (p.
• If no SFPs are used, the optical line interfaces must be equipped with "Dust Plugs"
(LPN: 700159437) to prevent dust and EMC emission. The dust plugs are part of
the 1643 AMS delivery.
...................................................................................................................................................................................................................................
4-52
STM-1 interfaces are available on the AMS main board and
Alcatel-Lucent - Proprietary
See notice on first page
8-2)).
365-312-802R7.2
Issue 4, June 2007