General information
Required tools and test equipment
...................................................................................................................................................................................................................................
Tools
A variety of tools is required to carry out the installation procedures. The following
table provides an overview of the required tools.
Table 2-5
Quantity
Description
1
Metric tool set
1
Torque wrench
1
ESD wrist strap
1
Soldering iron
1
RJ45 crimping tool
1
1.6/5.6 coax crimping tool
1
PC (Laptop)
Isopropanol, compressed air
and wipes
Test equipment
A variety of test equipment is required to carry out the individual tests. The following
table provides an overview of the required test equipment.
Table 2-6
Quantity
Description
1
SDH Analyser
(STM-1/STM-4)
1
Optical power meter
1
Multimeter
1
Adjustable optical attenuator
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Required tools
Required test equipment
Alcatel-Lucent - Proprietary
See notice on first page
Comments
to be used for physical installation
to be used when tightening the AM/AMS units to
the rackframe
to be worn when handling option boards and SFPs
to be used for soldering cables
to be used for terminating RJ45 cables
to be used for terminating 1.6/5.6 coax cables
to be used for NE provisioning via ITM-CIT
to be used for fiber cleaning
Comments
to be used for performing some installation tests
to be used for measuring the optical output power
to be used for measuring power supplies
to be used for measuring the receiver sensitivity.
A 15 dB LBO must be used for optical test loops or
for testing the individual ports.
2-15