Alcatel-Lucent 1643 AMS Installation Manual page 259

Cable assembly instructions
Coax connector (1.6/5.6)
...................................................................................................................................................................................................................................
Description
There are the following type of connectors:
• IMS — type 3320.52.1420.0D5 (45°)
• IMS — type 2630.52.1310.0D5 (Straight)
IMS
Important! Use of the correct tools to ensure a proper connection.
For assembling a coax 1.6/5.6 connector proceed as follows:
...................................................................................................................................................................................................
Strip the cable according to the dimensions indicated in the next figure and tin the
1
center conductor.
Important! The stripping lengths depend on the used connector type.
...................................................................................................................................................................................................
2 Pull the crimp outer ferrule over the stripped cable.
...................................................................................................................................................................................................
Pull back the cable braid.
3
...................................................................................................................................................................................................
Push the center conductor and the dielectric into the connector housing until the
4
dielectric stops.
...................................................................................................................................................................................................
Solder the inner conductor to the center contact of the connector housing.
5
...................................................................................................................................................................................................
After soldering press the cover into the connector body.
6
...................................................................................................................................................................................................
First roll the cable braid over the termination part (inner ferrule) of the connector and
7
pull the crimp outer ferrule over that braid.
...................................................................................................................................................................................................
Crimp the outer ferrule with a hexagon die 4.6 — AGK 3068 by using the Crimp Tool
8
— AGK 2365.
E
N D
...................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
O F S T E P S
Alcatel-Lucent - Proprietary
See notice on first page
C-5