Alcatel-Lucent 1643 AMS Installation Manual page 196

Stand-alone test procedures
Preparation and test of the main unit
...................................................................................................................................................................................................................................
Overview
This section describes the preparation and test of a 1643 AM/AMS main unit.
Estimated duration
15 minutes.
Procedure
Proceed as follows to perform the main unit test:
...................................................................................................................................................................................................
Connect the ITM-CIT to the NE.
1
...................................................................................................................................................................................................
Create the node. If available, use the operator specified name of the NE.
2
...................................................................................................................................................................................................
Provision the DCN parameter Area ID; set it to the operator specified value.
3
Note: If the Area Address is not available then we suggest leaving the unit isolated
until the value is available. The reason for this is that value 0000 is reserved for newly
installed units and should not be used in live networks. An NE in the isolated state if
the OSI protocol has not been activated. Getting the NE out of the isolated state is
done by editing the area address.
...................................................................................................................................................................................................
Verify that the requirements mentioned in the table below are met.
4
Result:
Node isolated:
LEDs on the 1643 AM/AMS:
Power:
Fault:
E
N D
...................................................................................................................................................................................................
...................................................................................................................................................................................................................................
7-6
O F S T E P S
Alcatel-Lucent - Proprietary
Requirements
No
On
Off
See notice on first page
365-312-802R7.2
Issue 4, June 2007