Alcatel-Lucent 1643 AMS Installation Manual page 185

ITM-CIT installation and NE provisioning
Slot state
Unassigned
Auto
Operation
When assigning units, an operation must be chosen. The choices are described in the
table below.
Operation
Assigned
Unassigned
Auto
Main unit
The unit provisioned or to be provisioned in the selected slot.
Upper/lower interface
The interfaces directly associated with the displayed Main Unit.
MIB state
The status of the MIB is indicated. The possible values are described in the table
below.
MIB state
Empty
Filled
Filled Unknown
Filled Not
Confirmed
....................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Description
Slot is unassigned
Slot is provisioned but waiting for unit. Once the provisioned
unit is present, the slot state will automatically change to
Assigned.
Description
Assigns the unit to the slot.
The slot is configured to be empty. The NE will not expect any
unit to be present in this slot.
Automatically assigns the unit to the slot once the NE
establishes the presence of a unit of the correct type. Until this
time, the slot acts as Unassigned.
Description
An empty System Controller (SC) has been inserted or the MIB
was cleared after starting an MIB download automatically by
the management system. If the MIB state is empty, the
management system can proceed with the MIB download.
The NE possesses a valid MIB which has been confirmed.
The NE has a MIB, however, it is of unknown validity. This
can occur, for instance, if one SC is replaced by another SC
having a MIB.
The NE has a MIB, however, it has not yet been confirmed by
the ITM-CIT. The procedure
(p. 6-22) gives the steps necessary to confirm the MIB. Once
confirmed, the state will become Filled.
Alcatel-Lucent - Proprietary
See notice on first page
"Confirm/Update the MIB"
Node creation
6-19