...................................................................................................................................................................................................................................

Installing the NE software

Overview

The procedures described below must be performed in case of a software download

failure occurred with the fast download application or if the fast download application

cannot be used.

For installing the E software manually, the following two procedures must be

performed:

E software download into an E

•

• Switch the Software Stores of the E.

These procedures can also be performed separately.

Before you begin

Before starting the E software download make sure:

• the required controller software is available on the management system or on floppy

disk.

• there is sufficient time to complete the procedure. The procedure lasts about one hour.

• not to download software into the backup store while the active store is not

committed. As long as the active store is not committed the E may perform an

automatic switch.

• not to forget to commit the software after performing a switch. If this is not done the

E will switch back to the previous active software after 2 hours.

Related information

Parameters used in this procedure can be found in section

installation" (p.

NE software download

Proceed as follows to perform the E software download:

...................................................................................................................................................................................................

Select

Result:

software currently stored in the active and backup store of the E.

...................................................................................................................................................................................................

Click

Edit.

Result:

...................................................................................................................................................................................................

Click

Download.

B-4

B-6).

Provisioning → Equipment → NE Software Configuration

The E Software Configuration window appears with information about the

The Edit E Software Configuration window appears.

Proprietary – Use pursuant to Company instruction

Alcatel-Lucent – Internal

Installing the NE software

"Parameters for E software

365-313-103R8.0