...................................................................................................................................................................................................................................

Overview

This test verifies the following:

• Checks the cabling with connections of all PDH ports with complementary wiring

according to the ODM

• Verifies that the labeling on the DDF matches the correct port number.

Estimated duration

20 minutes.

Test setup

The following figure illustrates a possible test setup.

Figure 7-1 E1 tributary ports distribution wiring test

Optical

loop

Note: For a long haul laser (L11, L12, L41 or L42) a 10 dB attenuator with applicable

connector is required in the loop.

Start condition

Be sure the following start condition is fulfilled:

• The procedure in section

been performed and the test results are correct.

• The ITM-CIT must be connected and logged-in to the NE.

• Test setup as shown in the figure above.

Procedure

Proceed as follows to perform the test:

...................................................................................................................................................................................................

Provision for each TP a cross-connection to LP1.

365-312-802R7.2

Issue 4, June 2007

TPx.1

AM/AMS

Line Port 1

TPx.y

Line Port 2

x= slot number

y= port number

"Preparation and test of the main unit" (p. 7-6)

Alcatel-Lucent - Proprietary