Alcatel-Lucent 1643 AMS Installation Manual page 191

7 S tand-alone test procedures 7
Overview
...................................................................................................................................................................................................................................
Purpose
This chapter describes all the tests that should be carried out to check the functionality
of the NEs.
Before you begin
Be sure all listed assumptions described below are fulfilled before carrying out any
tests:
• All NEs must be mounted and cabled correctly (see Chapters 3 and 4).
• The battery voltages are connected to the power connector and checked (see
chapter 5). An earth connection has been made.
• The correct software has been installed (see chapter 6).
• The area address must be available to enter into the DCN parameters. This is
required to get the unit out of the (OSI) isolated state.
• The people carrying out the tests are familiar with 1643 AM/AMS, the SDH
functionality, the ITM-CIT software and the handling of the test equipment.
Additional remarks
The following should also be observed:
• If the acceptance involves a 1643 AM/AMS NE without an option card and without
the DDF cabling, then the test is very limited, as all ports are factory tested.
• If a DDF is involved the connected cabling needs to be tested for each interface.
This is done by executing the port test on the DDF.
• If an option card is involved then each port of this card has to be tested on the
outlet of the 1643 AM/AMS or, if applicable, on the DDF, to prove a proper
function.
Contents
Test equipment and accessories
Preparation and test of the main unit
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
7-3
7-6
7-1