Alcatel-Lucent 1643 AMS Installation Manual page 102

System cabling
Power interfaces (AM unit)
...................................................................................................................................................................................................................................
Before you begin
Before connecting any power cables, be sure that all circuit breakers which are located
in the external Battery Distribution and Fuse Bay (BDFB) and/or on a Power
Distribution Panel (PDP) are in the
Important! The power cables should be connected later (see section
and testing supply voltage" (p.
DC connector data
The DC connector is a 9-pin SUB-D male connector.
Figure 4-1 DC connector (AM unit)
1
6
Table 4-1
Point on Connector
AC connector data
The AC connector is a 3-pin IEC 60320 universal connector (input power range: 90 to
264 VAC).
Cable data
Preferably stranded 0.51 mm
Cable connection
The power cables must be connected as shown in the figures below.
...................................................................................................................................................................................................................................
4-4
5
9
Pin assignment (power cables, AM unit)
1 –24/–48/–60 VDC, feed A
2 nc
3 DC RTN (return), feed A
4 nc
5 –24/–48/–60 VDC, feed B
6 nc
7 DC RTN (return), feed B
8 DC common return for feed A+B
9 GND (common ground)
2
wires with proper insulation should be used.
Alcatel-Lucent - Proprietary
See notice on first page
position.
OFF
5-3)).
Signal Name
"Switching on
Color
blue
red
blue
red
red
yellow/green
365-312-802R7.2
Issue 4, June 2007