Setting A Print Method For When A Received Image Exceeds Paper Size - Oki MC363 Advanced Manual

Setting a Print Method for When a Received Image Exceeds
Paper Size
• Specifying a Reduction Ratio
• Specifying a Threshold Value
The excess from the specified paper is reduced or discarded, or printed on the next sheet of
paper. For example, if the machine receives a fax that is larger than A4 with A4 paper
specified, the excess of the image is printed on the next sheet of paper.
You can avoid such situation by specifying a reduction ratio.
Specifying a Reduction Ratio
The reduction rate determines whether or not the machine automatically reduces the
received image to the specified paper size. [Auto] automatically reduces the image and
[100%] prints the image without reduction. [Rx Reduc. Rate] is set to [Auto] by factory
default.
1
Press the (SETTING) button on the operator panel.
2
Press the button once to select [Admin Setup] and press the
3
Enter the administrator password, and then press the
The factory default administrator password is "999999". If the administrator password is changed, enter the
updated password.
4
Press the button to select [Fax Setup] and press the
5
Press the button to select [Other Settings] and press the
6
Press the or button to select [Rx Reduc. Rate] and press the
7
Press the or button to select the reduction ratio for received fax, and
then press the (OK) button.
8
Press the button until the home screen is displayed.
Specifying a Threshold Value
Threshold means the value that determines the starting points to reduce or cut off to fit on
page when the received image exceeds the effective recording size.
• If the excess is larger than the specified reduction threshold value, the excess is printed on the next page.
• If the excess is smaller than the specified reduction threshold value, the received image is reduced and printed on
a page.
• If [Rx Reduc. Rate] is set to [100%] and the excess from the paper size is smaller than the specified threshold value,
the excess is discarded.
1
Press the
2
Press the
3
Enter the administrator password, and then press the
The factory default administrator password is "999999". If the administrator password is changed, enter the
updated password.
4
Press the
button.
5
Press the
(OK) button.
6
Press the
button.
7
Enter a value from 0 to 100 (mm) using the numeric keypad, and then press
the
button.
button.
If [Admin Setup] > [Manage Unit] > [System Setup] > [Unit Of Measure] is set to [Inch], enter a value from 0 to 3.9
(inches) and press the
button.
8
Press the
- 163 -
(SETTING) button on the operator panel.
button once to select [Admin Setup] and press the
button to select [Fax Setup] and press the
button to select [Other Settings] and press the
or button to select [Reduc. Margin] and press the
(OK) button.
(OK) button.
button until the home screen is displayed.
5. Fax
button.
button.
button.
button.
(OK)