Oki MC363 Advanced Manual page 284

• System Setup
Item
Access Control Disable
Default Authentication Method Setting Local Name
Unit of Measure Millimeter or Inch
Default Paper Size A4 or Letter
Default Scan Size A4 or Letter
Date Format dd/mm/yyyy or mm/
dd/yyyy
Allow All Reports To Print Disable
Near Life LED Enable
Near Life Status Enable
USB Memory Interface Enable
Panel Contrast 0
• Power Save
Item Factory default setting
Power Save Time 1 minute
Sleep Time 15 minutes
Auto Power Off Time 4 hours
Silent Mode ON
ECO Mode* 1 ON
Factory default Description
setting
Sets access control.
Available only when [Access Control] is set to
[Enable].
Selects a displayed unit (millimeter / inch).
Sets the default paper size.
Sets the default document size.
Sets the date format.
Sets whether to allow printing reports with
personal information.
Sets whether to light an LED if a near life
warning occurs.
Sets whether to display a message if a near
life warning occurs.
If [Disable] is set, the Scan To USB Memory
and the print from USB Memory functions
cannot be used.
Sets the LCD panel contrast.
Available range: ±10 (1 increments)
Description
Sets when to enter Power Save mode.
Sets when to enter Sleep mode.
Sets when to enter Auto Power Off.
Specifies a print preparation operation when
entering standby status from Sleep mode.
If [ON] is set: it is quiet as there is no print
preparation.
If [OFF] is set: there is a rotation noise of the
image to perform print preparation but you
can start first printing early.
If [ON] is set: Printing starts even before the
temperature of the fuser reaches the
prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the
temperature of the fuser reaches the
prescribed degrees.
• Memory Setup
Item Factory default setting
Receive Buffer Size Auto
Resource Save OFF
• Flash Memory Setup* 1
Item
Initialize
Format Partition PCL
Common
PS
• Storage Maintenance Setup
Item Factory default setting
Check File System Execute
Initial Lock Enable
• Language Maintenance Setup
Item Factory default setting
Select Language English
Initialize* 1 Execute
• Admin Password
Item Factory default setting
New Password 999999
Verify password
- 284 -
9. Operating Management/ Specifications
Description
Sets the reception buffer size that local
interface secures.
Sets the resource save area.
Factory default Description
setting
Execute Initializes a flash memory.
This item is displayed when [Initial Lock] is
set to [Disable].
(NULL) Formats a partition.
(NULL)
(NULL)
Description
Resolves any mismatch between actual
memory and displayed memory available in a
file system and performs administration data
(FAT information) recovery.
Sets whether to give permission to change
settings associated with the memory
initialization.
Description
Selects display language for the LCD panel.
Deletes downloaded message files.
Description
Changes the administrator password. 1 to
32 characters can be used.