Installation
Intended use
Festo P.BE-CTEU-CO-OP+MAINT-EN en 1101NH
The bus node type CTEU-CO described in this manual has
been designed exclusively for use as a slave on the CANopen
field bus.
The bus node may only be used as follows:
–
as intended
–
in original condition, without any modifications by the
user.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
–
in perfect technical condition.
The limit values specified for pressures, temperatures,
electrical data, torques etc. should be observed.
Observe the regulations of the trade associations, German
Technical Control Board (TÜV), VDE stipulations or corres-
ponding national laws and regulations.
Warning
Use only PELV circuits as per IEC/EN 60204-1 for the
•
electric power supply (protective extra-low voltage,
PELV).
Also observe the general requirements for PELV circuits
in accordance with IEC/EN 60204-1.
Use only power sourcesthat guarantee reliable electrical
•
isolation of the operating voltage as per IEC/EN 60204-1.
Protection against electric shock (protection against direct
and indirect contact) is guaranteed in accordance with
IEC/EN 60204-1 by using PELV circuits (electrical equipment
of machines, general requirements).
V