Signals List - IntesisBox IBOX-MBS-KNX-100 User Manual

Modbus Server – KNX
®
IntesisBox

5.1.2 Signals list

Select the Signals tab to configure the signals list (the IntesisBox
Description Enumeration of the rows in the grid (signals). If clicked on them the whole
row will be selected (to be used to delete/add rows
Restrictions Cannot be edited
Description Select the type of signal
Values
Restrictions Cannot be edited
Description Signal's description (optional). Used to describe the signal at user level.
Restrictions 30 characters maximum
Comments If the description gives some good information about the physical location of
the KNX point related, it may help during the gateway's integration phase
into the Modbus system.
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SLU
Figure 4.6 Signal list
# (Signal's number)
 Communication Error: indicate to the Modbus side a communication
error within the KNX system
 Data: for normal signals
Data type
Description
URL
Email
tel
User's Manual r18 eng
® internal points).
http://www.intesisbox.com
info@intesisbox.com
+34 938047134
21 /
31