Table of Contents
Advertisement
Modbus Server – KNX
®
IntesisBox
1. Install LinkBoxMB. Details in section 5.
2. Install IntesisBox in the desired installation site (DIN rail mounting inside a metallic
industrial cabinet connected to ground is recommended).
3. Power up and connect the communication cables. Details in section 4.
4. Open LinkBoxMB, open a project or create a new one. Details in section 5.
5. Connect to the IntesisBox (details in section 4).
6. (optional) Configure the IntesisBox. Details in section 5.1
7. Check if there is communication in both Modbus and KNX buses (section 5).
8. The IntesisBox is ready to be used in your system.
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
3. Quick Setup
User's Manual r18 eng
URL
http://www.intesisbox.com
Email
info@intesisbox.com
tel
+34 938047134
12 /
31
Advertisement
Table of Contents
Need help?
Do you have a question about the IBOX-MBS-KNX-100 and is the answer not in the manual?
Questions and answers