<Calendar Type>
Select for originals whose images on the front and back sides face in opposite directions.
●
For information about other scan settings, see
between File Size and Image Quality(P. 255) .
●
For e-mail, you can specify the subject, message, reply-to address, and priority as necessary.
E-Mail Settings(P. 258)
7
Press
.
➠
Scanning of the original starts.
●
If you want to cancel, select <Cancel>
When placing originals in the feeder in step 1
When scanning is complete, the sending/saving process starts.
When placing originals on the platen glass in step 1
When scanning is complete, follow the procedure below (except if you selected JPEG as a file format).
1
If there are additional pages of originals to be scanned, place the next original on the platen glass, and
press
.
●
Repeat this step until you finish scanning all of the pages.
●
When there is only one page to be scanned, proceed to the next step.
2
Select <Start TX>.
➠
The sending/saving process starts.
File name of the sent document
●
The file name of a sent document is automatically assigned based on the following format: communication
management number (four digits)_sent date and time_document number (three digits).file extension
name.
If an E-Mail Send Error Occurs
Error notifications are sometimes sent to the e-mail address set to the machine. If you leave it as-is, it may
result in an insufficient remaining capacity of mailbox depending on your mail server. It is recommended that
you clear the mailbox periodically.
To clear the mailbox
●
When the mailbox is cleared, all e-mail in the server mailbox is deleted. When you specify the e-mail
account that you use usually, you should first check whether any e-mail in the mailbox needs to be kept.
1
Start the Remote UI and log in to System Manager Mode.
2
Click [Settings/Registration] on the Portal page.
3
Select [Network Settings]
Scanning
Scanning Clearly(P. 250)
<Yes>.
Canceling Sending Documents(P. 246)
Remote UI Screen(P. 335)
[E-Mail Settings].
244
or
Starting Remote UI(P. 334)
Adjusting Balance
Specifying